China cancels steel export tax rebates to boost supply

  • Market: Metals
  • 04/28/21

From 1 May, China will revive taxes on steel exports and cut tariffs for ferrous imports in a bid to shore up domestic supply and slow the growth of carbon emissions.

Tariffs will be cancelled on imported billet, pig iron, crude steel and recycled steel raw materials and increased on exports such as high-purity pig iron, Customs Tariff Commission of the State Council, China's cabinet, said today.

Rebates will be eliminated for the 13pc value-added tax (VAT) on steel exports, including hot-rolled coil (HRC) and rebar, that were put in place a year ago to offset a slowdown from lockdowns.

"The tax adjustments are aimed at reducing import costs and expanding imports of steel resources. It will support reduced domestic crude steel production and reduce the steel industry's total energy consumption. This will promote the transformation and upgrading of the steel industry," the commission said.

The tax amendments, anticipated since February, are intended to slow growth in steel-sector carbon emissions ahead of a peak in 2025 and rein in soaring costs.

Iron ore prices rose to new 10-year highs this week, with steel production near record levels. Its largest mills raised crude steel output to a record level in mid-April after China's total output increased to its second-highest level in March. Tangshan billet is holding at 13-year highs and Argus assessments for Shanghai HRC and rebar are near their highest levels since they launched in 2016 and 2018, respectively.

Beijing will cancel rebates for the 13pc VAT on exports on more types of steel products than expected. These include HRC, hot-rolled sheet, plate, rebar, wire rod, colour-coated steel and cold-rolled sheet with 0.5-3.0mm and below 0.5mm thickness. It also cancelled rebates on round bar and section, stainless steel products with width above 600mm, seamless steel pipe, steel strips with 600-880mm thickness and galvanised corrugated sheets.

It made no changes to rebates for duties on exported cold-rolled coil and hot-dip galvanised steel.

Chinese exporters began adding the cost of the VAT into offers last month or required buyers to bear the costs of any tax policy changes. The uncertainty temporarily froze export spot trade until overseas price strength pushed buyers to accept offers that included the tax costs.

The Chinese HRC export index has risen by $160/t, or 22pc, to $923/t fob China this month.

Viewpoints are mixed on whether the tax amendments will shore up China's domestic steel supply. If the tax policy is tied in with policies to reduce steel output, as one agency has pushed for this year, it could support prices.

A significant shift in the supply from exports to imports could weigh on prices. "I suspect local steel prices in China will come down" with the cancellation of steel export rebates, a pig iron seller said.

Beijing increased the export duty on high-purity pig iron under HS code 72011000 to 15pc from 10pc and eliminated a 1pc duty on non-alloyed pig iron imports with HS code 72011.

"Pig iron prices cfr China basis are at about the $550/t level. Domestic China prices are lower than international levels and therefore the tax removal will not change short-term dynamics," the pig iron trader said.

Beijing removed a 2pc import tax on the two remaining ferrous scrap HS codes 72041000 and 72044100 that were not zeroed out at the beginning of the year. Most ferrous scrap imports are already tax-free and the two HS codes accounted for less than 10,000 t/yr over 2016-18 before the import ban that ended on 1 January.


Sharelinkedin-sharetwitter-sharefacebook-shareemail-share

Related news posts

Argus illuminates the markets by putting a lens on the areas that matter most to you. The market news and commentary we publish reveals vital insights that enable you to make stronger, well-informed decisions. Explore a selection of news stories related to this one.

News
03/18/24

New Asean flat steel mills to affect Turkish imports

New Asean flat steel mills to affect Turkish imports

London, 18 March (Argus) — Expanding steelmaking capacities in Malaysia and Indonesia, led by Eastern Steel and Dexin Steel, this year will most likely reshape the Turkish import market going forward. China last year was Turkey's chief supplier of flat products, with volumes increasing as a result of the outbreak of the war in Ukraine in 2021 and as Chinese exports rose amid sluggish domestic demand. China could continue being a key source for Turkish buyers, but its share of the country's import market may be affected by new sellers. Towards the end of this year, Malaysia's Eastern Steel will bring on line 3.5mn t/yr of flats. The steelmaker aims to export about 2.2mn t/yr of hot-rolled coil (HRC) to foreign countries, with Turkey being a key market, according to a company source. Malaysia already benefits from a free trade agreement (FTA) with Turkey that makes steel product imports exempt from the 13-15pc customs duty. Similarly, Indonesia is in the process of finalising its own FTA with Turkey, with talks still ongoing. This makes Indonesian steelmaker Dexin Steel's project to open a new flat steel mill towards the end of this summer, with a rolling 4mn t/yr stainless and carbon flat products capacity, another potential duty-free source for Turkish buyers. The prospect of anti-dumping duties being introduced this year on Chinese, Indian, Russian and Japanese HRC also could help usher in greater interest and consumption of flat products from alternative suppliers. But the majority of buyers in Turkey operate with inward processing regime licences when purchasing imported HRC, which exempts them from any form of import duty, but with the caveat that they cannot use the material for domestic market consumption. If anti-dumping duties were to be introduced, Malaysian and possibly Indonesian coil could join Egyptian as sources for raw material for domestic market consumption. Egyptian HRC trades at a price premium to Chinese and other origins, subject to customs duties, which could imply a similar differential for Malaysia and Indonesia. "Malaysia will be key for Turkey's steel supply chain going forward," a market participant said. A buyer that is active in the export market expressed its willingness to buy from Malaysia on a monthly basis once their capacities come on line. Turkey last year imported 150,000t of flat products from Asean countries, with 98,000t of this having come from Indonesia and the remaining 52,000t from Vietnam. Activity from the Asean region into Turkey could increase, supported by Malaysia, while Indonesia's role will depend on the outcome of FTA talks. It is interesting to note that Eastern Steel and Dexin Steel are joint venture projects by Chinese steelmakers aiming to expand capacities in foreign markets. This growing trend is underpinned by myriad trade restrictions across international markets on Chinese producers. Eastern Steel is partly owned by Beijing Jianlong Heavy Industry Group, while Dexin Steel is under the control of Shanghai Delong Iron and Steel Group. By Carlo Da Cas Send comments and request more information at feedback@argusmedia.com Copyright © 2024. Argus Media group . All rights reserved.

Read more
News

Tata Steel to close Port Talbot coke ovens


03/18/24
News
03/18/24

Tata Steel to close Port Talbot coke ovens

London, 18 March (Argus) — Tata Steel will close its ageing Port Talbot coke ovens this week. The ovens are old, and Tata had instructed unions that they would probably have to close promptly even without its decarbonisation drive . The Synergy report drawn up for trade unions, which recommended keeping a blast furnace open alongside the hot strip mill, accepted the closure of the ovens. There are around 84 ovens at Port Talbot, and about a third of these have been working of late. Tata will increase coke imports to offset the closure of the ovens, the company said. The Unite union is balloting its members over industrial action because of the closure of the mill's hot end, but the Community union has so far held off from balloting as it continues its consultations with Tata. The last coke produced at the site, indeed the last coke to be made in the UK, will be on 20 March. By Colin Richardson Send comments and request more information at feedback@argusmedia.com Copyright © 2024. Argus Media group . All rights reserved.

News

Meranti Green Steel signs deal with German trader


03/18/24
News
03/18/24

Meranti Green Steel signs deal with German trader

London, 18 March (Argus) — Germany-based steel trader Interfer Edelstahl Handelsgesellschaft has signed a memorandum of understanding with Singapore-based Meranti Green Steel for the offtake of low-carbon hot-rolled coil for the European market. Meranti is in the process of building an electric arc furnace-based steel plant in Thailand, which from 2028 will produce 2-3mn t/yr of HRC, fed by continuously cast slab. Interfer and its joint venture partner Belmont & Knott, which trades flat steel into the EU and UK markets, are Meranti's first offtake partner for steel — the company has signed a number of MOU's with raw material suppliers, including Anglo American and Glencore. Meranti is eyeing the EU as a potential market for its products given the bloc's carbon border adjustment mechanism, which will see importers pay a tax depending on the carbon intensity of their steel. Meranti's HRC, which it plans will be fed with DRI and 10-20pc green hydrogen from 2028 and leverage on renewable energy in its steel making processes, will have a carbon intensity of less than 600kg/t, compared to the global average intensity of around 2t at present, the company said. It intends to ramp up its usage of green hydrogen as availability increases and cost falls, culminating in a minimal carbon footprint by 2040, when it targets using up to 90pc of green hydrogen. Meranti has agreed to collaborate with Green Steel of WA on the production of DRI in Western Australia, which will feed its Thai mill. By Colin Richardson Send comments and request more information at feedback@argusmedia.com Copyright © 2024. Argus Media group . All rights reserved.

News

Japan's JFE Shoji eyes stake in metal firm Arfin India


03/18/24
News
03/18/24

Japan's JFE Shoji eyes stake in metal firm Arfin India

Tokyo, 18 March (Argus) — JFE Shoji, a Japanese trading house that focuses on steel products and their feedstock, today agreed to acquire a stake in Indian aluminium goods and ferro-alloy manufacturer Arfin India. JFE Shoji did not disclose the size of the stake or investment amount. Arfin India is a major producer of aluminium deoxidizers made from recycled scraps. Aluminium deoxidizers are used to remove oxygen during the steelmaking process. Arfin India has a production capacity of 20,000 t/yr for aluminium deoxidizers and 21,000 t/yr for aluminium alloy ingots. It also produces other products like aluminium wire rods and ferro-titanium. JFE Shoji has decided to buy a stake in Arfin India in anticipation of growing demand for recycled aluminium deoxidizers in India, as well as Asean member countries. Recycled aluminium deoxidizers require less energy to generate and does not emit as much CO2 emissions compared with the output process for conventional feedstock like bauxite. JFE Shoji sees continuous growth in steel manufacturing in India, citing accelerating infrastructure development. It aims to sell recycled aluminium deoxidizers in India and Asean countries but does not plan to import them into Japan. JFE Shoji previously acquired US steel frame manufacturer California Expanded Metals Products. By Nanami Oki Send comments and request more information at feedback@argusmedia.com Copyright © 2024. Argus Media group . All rights reserved.

News

Banking consortium backs Chilean copper expansion


03/18/24
News
03/18/24

Banking consortium backs Chilean copper expansion

Tokyo, 18 March (Argus) — A consortium of banks is putting together a $2.5bn loan for Chile's Centinela copper mine, a joint venture between Japanese trading house Marubeni and its UK-based partner Antofagata. The state-backed Japan Bank for International Co-operation (JBIC), Export Development Canada, Exim Bank of Korea and German's KfW Ipex-Bank, along with private-sector banks, signed a loan agreement with Chile's Minera Centinela that Marubeni and Antofagata own, according to JBIC on 18 March. The funding will form part of the $4bn project costs that Marubeni and Antofagata estimate for Centinela to expand output by 140,000 t/yr . The additional funding by the consortium of banks will accelerate the development, said Marubeni, expecting it to start commercial operations in 2027. Japanese firms are expected to secure some copper offtake from the expanded mine, according to JBIC, although volumes were undisclosed. Marubeni will have 30pc of Centinela and Antofagata 70pc after the expansion, said Marubeni. The expansion will involve the construction of a new concentrator plant located 7km south of the mine's existing concentrator, which will double Centinela's copper concentrate capacity. Marubeni announced last week it was buying into Canada-based mining firm Hudbay Mineral's copper exploration projects in Manitoba. The two companies signed an option agreement for Marubeni's Canadian subsidiary to acquire a 20pc stake in three projects near Hudbay's currently idle Flin Flon processing facilities. By Yusuke Maekawa Send comments and request more information at feedback@argusmedia.com Copyright © 2024. Argus Media group . All rights reserved.